HMS H9244, Manual Instruction

Page: 21 / 37

6). Install the Handlebar Support (Right & Left)
a. Attach one Arc spacers (9) and Wave washer (28) to
the right end of horizontal axle of Front upright frame
(14).
(make the gouge of the arc face inside)
b. Insert right Handlebar support (6R) to the right end of
horizontal axle of Front upright frame (14) (the long side
of the handlebar face inside) and secure it with one
Plastic flat washer (53),
Φ8 Big washer (49), Φ8 spring
washer (51), M8 Special washer (16), and M8
×20 Bolt
(36).
c. After assembled the Nut cap (7) to the M8
×20 Bolt (36), the right Handlebar support (6R)
can move freely.
d. Do the same steps as the above to assemble the left Handlebar support (6L). (Refer figure
6)
7). Install the Pedal Support Tube (Left & Right)
Insert the left Pedal support tube (4) through the Rear U-shape bracket (35), put a Wave washer
(28) and Pedal axis bushing (54) into the Left pedal axis (30). And then attach the pedal axis
(30) to the crank (67) and tighten them. Do the same steps as above to assemble the right
Pedal support tube (4) to the right pedal axis (30). (Refer figure 7)
Note: The left & right screw thread should be fixed accordingly, and there is some labels stick
on the parts: left screw thread
“L”, right screw thread “R”.
8). Install the Pedals
Attach the left Pedal (5) to the left Pedal support tube (4) with four M8x50 Bolts (37),
Φ8 Flat
washers (50), and M8 Lock nuts (42). Do the same steps as above to assemble the right Pedal
(5) to the right Pedal support tube (4). (Refer figure 8)