11 (44)
4
Configuration
4.1
General
Anybus Wireless Bridge II can be configured via the web interface or using one of the pre-
configured
Easy Config
modes.
Advanced configuration can be carried out by issuing AT (modem) commands through the web
interface or over a Telnet or RAW TCP connection to port 8080. For more information about
using AT commands, please refer to the
AT Commands Reference Guide
.
4.2
Easy Config
1.
Power on the unit and wait for the
Link Quality
LEDs to light up and go out again, then
immediately press and release the
MODE
button.
2.
Press
MODE
repeatedly to cycle through the Easy Config modes until the desired mode is
indicated by the
A-B-C-D
LEDs.
3.
Within 20 seconds of step 2, press and hold
MODE
for 2 seconds. When the button is
released the unit will restart in the selected mode.
4.2.1
Easy Config Modes
EC
LED
Role
Description
1
A
Bluetooth PANU
Configure as a client and scan for another client (PANU to PANU).
2
B
–
Reset configuration to factory defaults.
3
A
B
–
Reset IP settings to factory defaults.
4
C
Client
Wait for automatic configuration.
5
A
C
WLAN AP
Configure units in mode 4 as clients.
Restart as access point and connect clients.
6
B
C
Bluetooth NAP
7
A
B
C
WLAN AP
Configure units in mode 4 as clients.
Restart as access point and connect clients.
Apply PROFINET optimization to all units.
8
D Bluetooth NAP
9
A
D Bluetooth PANU
Configure as a client and scan for another client (PANU to PANU).
Apply PROFINET optimization to both units.
10
B
D (any)
Apply PROFINET optimization and restart.
11
A
B
D (any)
Enable PROFIsafe mode.
The Easy Config modes are also described when selected in the web interface.
Anybus
®
Wireless Bridge II
™
User Manual
SCM-1202-032 1.10 en-US
