HMS ABI17-19-027, Manual Instruction

Page: 23 / 66

22
36 J40X20 End cap 4 A12
Shoulder boltΦ8 X 25
1 D4 Cross screwdriver 1
Remark
：
Parts subject to our available products if there is any discrepancy.
WARNING: Don’t insert the power wire until the treadmill was fully assembled.
Assembly tips:
2.In order to avoid instruction mistake, do not tighten bolt completely until the whole treadmill assembly is finished.
3.This treadmill packaged for 2 cartons. #1 carton is main frame.#2 carton is Handlebar set.
1
．
Assembly of left upright tube
1.1Install left upright tube (4) to base frame (3) by using two sets half-round bolt M8*55(A7) and M8*65(A8) on the
side.
1.2 In the rear, use one piece of half-
round bolt M8*20(A5) and 1piece flat washer φ8(C3) to connect. (As Figure 1
shown).
2
．
Assembly of right upright tube
2.1Thread the Signal wire (55) from Base frame to
the upper end of the Right upright tube and fix it.
2.2Install the Right upright tube(5) to the Base
frame(3) by using two sets Half-round bolt
M8*55(A7) and Half-round bolt M8*65(A8) on the
side.
2.3In the rear, use one piece of Half-round bolt
M8*20(A5) and one piece Flat washer φ8(C3) to
connect. (As Figure 2 shown).
3. Assembly of handlebar and controller
3.1Thread the Signal wire (56) inside the Handlebar through the upper
side of Upright tube, then connect the Handlebar(7) to the upright tubes
(4/5).
3.2 Use six pieces of Half-round bolt M8*20(A5) to connect (As Figure 3
shown).
3.3Connect the Signal wire in the upright tube and the corresponding
wire in the controller, then insert into the upright tube.
3.4 Use four sets of Half-
round M10*20(A10) , Spring washerφ10
（
C11
）
and Flat washer φ10
（
C4
）
to connect the upright tubes to the
controller (As Figure 4 shown).
4. Assembly of tablet PC holder
4.1 Align the holder with the turnable pedestal, then connect them by
using four sets of Cross pan head bolt (A16), Spring washerφ4
（
C9
）
and Flat washer φ4
（
C1
）
(As Figure 5 shown).