Intesis
TM
KNX
– Mitsubishi Heavy Industries AC
User’s Manual r1.2 eng
© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
URL https://www.intesis.com
14 / 26
Connect to KNX Interface
C and
–
terminals of the KNX bus to the Intesis
TM
KNX connector (C1). The polarity
is important.
How to check if there is communication with the KNX bus is explained in the LinkBoxEIB
Manual (section 6.3).
To check connectivity and correct functioning, use LinkBoxEIB software (see LinkBoxEIB
User Manual).
Connect to PC (LinkBoxEIB)
This action allows the user to have access to configuration and monitoring of the device
(more information can be found in the LinkBoxEIB User Manual).Two methods to connect to
the PC can be used:
•
Ethernet: Using the ETH port (
Figure 3.1
) of Intesis
TM
. How to check connectivity is
explained in section 6.3.
•
Serial cable: Connect the Intesis
TM
device to the PC serial port using the serial cable
provided. One end should be connected to the Console EIA232 port of the Intesis
TM
device (
Figure 3.1
) and the other end to the PC serial port.
Intesis
TM
(DB9 F)
EIA232
Serial
Console
PC Connection (LinkBoxEIB)
PC
(DB9 M)
Cable
(DB9 M)
EIA232
(Straight)
Cable
(DB9 F)
TX
2
2
RX
RX
3
3
TX
GND
5
5
GND
Table 3.3
EIA232 serial connection pin assign
Power Device
To power up the device, what you need is to plug properly the Power Supply connector to
the Intesis
TM
device using a proper cable and connecting one end to the power supply
connector (see Figure 3.2) and the other end to the power line. After that, just press the
power supply On/Off button to turn it on.
