8 (40)
3.5
Ethernet Cabling
To make an Ethernet connector cable for Anybus Wireless Bolt:
Fig. 3
1.
Cut off one of the connectors on a standard Cat5e or Cat6 Ethernet cable.
2.
Strip off about 40 mm (1½ inch) of the cable jacket and untwist the orange, orange/white,
green and green/white wires. The other wires will not be used.
3.
Strip off about 7 mm (¼ inch) of the isolation on each wire.
4.
Push the pin spring release next to each socket on the connector and insert the correct wire
end according to
.
Connect the wires from the power supply to the connector in the same way as the Ethernet
wiring.
Make sure that polarity is not reversed.
RJ-45 Adapter
An Ethernet adapter with an RJ45 female connector can be ordered as an accessory. Please
contact your sales representative for more information.
3.6
Digital Input
The digital input can be used to control roaming between Bluetooth access points (NAP). For
more information, refer to the AT Reference Guide at
If voltage is applied to the digital input for more that 10 seconds the unit will be reset to
factory defaults.
Anybus
®
Wireless Bolt
™
User Manual
SCM-1202-007 2.8 en-US
