HME DX100 EU, Operating Instructions Manual

Page: 18 / 34

13
If registration is successfully completed:

A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration,
Registration complete, …”

After a delay of up to 15 seconds, the
REGISTRATION STATUS
display will show the ID number
assigned to this Beltpac for about 10 seconds.
NOTE:
ID numbers are assigned sequentially as 0 thru 9, A, b, C, d and E.

The power light on the Beltpac, next to the
IC
button, will remain on steady green.

Repeat Steps 1 to 3 at the bottom of page 12 for each Beltpac to be registered.
If registration failed:

A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration, …” Both
power lights on the Beltpac will be blinking red, and there may be a delay of up to 90 seconds before
you hear “Registration failed”.

Press the
RESET
button on the base station. When the
REGISTRATION STATUS
display becomes
blank, press the
REG
button on the base station and register the Beltpac again. If registration fails
again, call your dealer for assistance.
If you try to register more than 15 Beltpacs and/or Headsets to a base station
:

An
F
(for registration “Full”) will appear on the
REGISTRATION STATUS display on the base
station, and you will hear “Registration failed” in
the headset.

Clear all current registrations by pressing the
CLR/ BND
button and the
RESET
button
simultaneously. Release the RESET button, but
continue holding the CLR/BND button until the
clear code “
c
” (lower case) appears on the
REGISTRATION STATUS
display.

Register all active Beltpacs, one at a time.
Previously registered WH220 Headsets must also be
re-registered.
REGISTRATION
STATUS display
CLR/BND
button
REGISTRATION
STATUS
display
RESET
button