©
2022 HM Electronics, Inc. All rights reserved.
2
CHANGING POWER SUPPLY ADAPTER
1. Replace power adapter (P/N: CON-00004) to
match your country's outlet using your thumb and
forefinger to squeeze the latch (see Fig. 4).
2. While squeezing the latch, slide the adapter out,
away from the power supply to remove.
3. Release the latch and slide the appropriate adapter
on until it bottoms out and the latch clicks to secure
it in place.
Press in here on both sides of latch to release
Slide in these directions to remove and replace
Latch
Adapter
Fig. 4
TECHNICAL SPECIFICATIONS
Power Supply:
Wall plug with switchable adapters
Input Voltage: Universal 100 - 240 VAC nominal
Output Voltage: 5V; 4A
MTBF: 300,000 hours calculated
AC70 Battery Charger
Input Voltage: 5V; 4A
Charge Output: ~ 3W per port
Temperature
Operating: 32°F to +104°F (0°C to +40°C)
Storage: 4°F to +176°F (-20°C to +80°C)
Humidity Range (non-condensing)
Storage: 0% -95%
Dimensions
5.09” L x 3.64” W x 1.84” H
(129.2 x 92.4 x 46.7 mm)
Weight
0.373 lb (0.169 kg)
Wireless PAN
2.4 GHz Wireless Technology
A copy of this guide and additional information including Regulatory,
Compliance, and Safety information can be found under NEXEO | HDX by
scanning this QR code or going to:
https://www.hme.com/qsr/drive-thru-user-manuals/
The HME logo and product names are registered trademarks or
trademarks of HM Electronics, Inc.
2”
(50.8 mm)
Wall Mounting Template for AC70
1. Hold template against the wall,
2. Use a marker to punch through the paper
template at the two crosshairs to mark the
wall.
3. Drill two holes at the marks on the wall (avoid
electrical or plumbing obstructions).
4. Install the provided hardware but do not
tighten. Leave a gap (~ ¹/
8th
inch (3.2 mm))
between the screw heads and wall.
5. Align the AC70 mounting keyholes with the two
screw heads (Fig. 2).
6. Mount the AC70 over the screw heads until
flush against the wall, then slide it down onto
the screw shanks to secure it in place.
