(6) Reinstall the removed section of the intercooler piping.
(7) Connect the SSQV to the intake manifold source such as:
A. Factory fuel pressure regulator
B. A pressure fitting after the throttle body
If necessary, use one of the provided T-fittings to splice into an existing hose. (Dia.4)
(8) Install the vacuum filter between the SSQV and the source
of the intake manifold pressure (with the short end going to
the SSQV). (Dia.4)
(9) Install the vacuum hose using the provided vacuum filter.
Attach the other end to the SSQV. Cut the 4mm hose to the
appropriate length. (Dia.4, 5)
(10) Secure the 4mm Hose connected to the SSQV Fitting
using a Tie Wrap. (Dia.4, 5)
ADVICE:
When uninstalling the SSQV Assy or when removing the 4mm hose from the SSQV Assy, remove the Tie Wrap, cut the hose
past the port on the SSQV Assy, and slice the 4mm Hose lengthwise and then remove the 4mm hose. (Dia.5)
Do not pull or wriggle the 4mm Hose using pliers or other tools to prevent damage to the SSQV Assy.
The SSQV must be activated by intake man-
ifold pressure.
(11) Inspect all parts for proper installation. Verify the SSQV Assy is securely mounted to the flange and the C-clip is installed
correctly. Make sure the manifold pressure hose is not pinched and there are no holes or cuts on it.
(12) If the SSQV is mounted near the hood or any other part, make sure the SSQV Assy has adequate clearance so it does not
come in contact with other parts.
(13) Reconnect the battery cable to the negative terminal of the battery.
8
