Hkoenig HWP5, Instruction Manual

Page: 13 / 109

Operation
Special accessories expand the possibilities of using your
appliance. Please contact the dealer for further information.
Illustrate accessories before start-up.
1.Install coupling for water connection (pic A).
Screw the coupling to the water connection on the appliance.
2.Install high pressure hose (pic B. pic K).
Insert the high pressure hose tightly in to coupling on the
appliance, it will lock in audibly. Note: make sure the connection
nipple is aligned correctly. Check the secure connection by
pulling on the high pressure hose.
3. Install the storage of trigger gun (pic C).
Insert the storage of trigger gun and push down all the way
4. Install spray lance (pic F).
Push the spray lance into the trigger gun and fasten it by turning
it through 90 degree.
Water supply
Impurities in the water can damage the high pressure pump and
accessories. All high pressure washer (except hot water system)
use the cold water. The suitable water temperature is 5
℃ to
60 ℃ .
Water supply from mains
Observe regulations of water supply
For connection values, use fibre-reinforced water hose (not
included) with a standard coupling, normally the length is 5m,
connect the water hose to the appliance and water supply.
1.
Open the water tap
2.
Unlock the lever on the trigger gun 3.Pull on the lever of
the trigger gun
4.Turn on the appliance (pic G ON: open OFF: close)
Start up
Dry runs lasting longer than two minutes lead to damages to the high
pressure pump. If the appliance does not build up pressure within
two minutes, switch it off and proceed as instructed in the
Chapter “Troubleshooting”.
The trigger gun is subjected to recoil force when the water
washer is discharged. Make sure that you have a firm footing and