5.8G Real-Time Transmission Transmitter
Component Installation Instructions
Real-Time Transmission Display Screen
Installation Instructions
The four pillars (Image 1) 5.8G real-time transmission transmitter
component corresponding to (Image 2) (A) are installed , screw
them . Then connect the plug (Image 2) (C) to 2 pin socket.
The fixed handle under cover (Image A) to the handle (ImageD),
(Image B) display screen . Directly fixed buckle to the handle
(Image D ). (Image E ) is installed . And then fixed by screw ,
Connect the wire (Image C), power DC socket connect to the
display screen ,connect another DC socket behind the remote
controller.
Ⅰ
. Turn on/Turn off
Turn on: Connect the power, long press 5.8G screen "power switch" button for 3~5 seconds. The display screen light will
display the Huajun Aeromodelling Logo.(Image F);
Turn off: Turn off after using , press 5.8G screen "power switch" button for 3~5 seconds, the display screen out .
Ⅱ
.Menu Introduction:
The menu consists of two small menu, as shown in the following image.
(Menu 1 & Menu 2)
Menu 1
Menu 2
5.8G Real-Time Transmission Display
Operating Instructions
：
Ⅰ
.Brief Introduction
：
Ⅱ
.Function Description:
1
5.8Ghz FPV Device
INSTALLATION AND OPERATION
Image A
Image B
Image C
Image D
Image E
Image 1
Image 2
Socket
SD Card
Reader Slot
ON/OFF
OK
UP/Video
DOWN
Menu
Screen
camera
screw
2
TF Card
Slot
1
