HIVILUX RXN Series, Instruction Manual

Page: 8 / 16

Note:
Once all eight corner braces and frame rails are in place you want to check
each corner to make sure the corners are aligned properly. There should
be an even point at each corner where the frame rails jointogether. You will
have a 1mm gap at the miter cuts in the back where the frame rails join
together. This gap is caused by the velvet wrapping around the front ends
of each frame rail. This gap is only in the back of the frame and is not seen
in front of the frame.
Please read the step 4 directly for the non center joint model.
6