Hitron 50201270, Instruction Manual, Page: 21 / 25

Troubleshooting and Maintenance
6
6.1 TROUBLESHOOTING
If problems occur, verify the installation of the camera with the instruction in this
manual and with other operating equipment.
Isolate the problem to the specific piece of equipment in the system and refer to
the equipment manual for further information.
14
NOTE 1 : You can choose BPS menu appropriate for keyboard protocol.
NOTE 2 : Although you change BAUD RATE or PROTOCOL menu,
the terms of change is not applied unless you select SAVE menu.
NOTE 3 : Does not do power source down while saving
PROBLEM POSSIBLE SOLUTION
Nothing appears on the screen Are the power cord and line connection between the
camera and monitor made properly?
The image on the screen is dim. Is the lens dirty?
If so, clean the lens with a soft, clean cloth.
CAM ID Select the camera ID.(1~255)
BAUD RATE Select serial communication speed. (2400/4800/9600/19200bps)
PROTOCOL Select operating protocol.
(FASTRAX/PELCO-P/PELCO-D/COMMAND)
DISP MODE Select display mode.(ON/OFF/PUSH ON)
DISP ITEM Select display item.(1~2)
1 Camera Title and ID display.
2 Camera Title and ID, Zoom lens position display.
TITLE Select camera title menu.(A~Z, 0~9)
ALARM TEXT If the alarm is occurred, the ALARM TEXT established at this menu
will be displayed.
SAVE Save preset parameters of CAM SET MENU.
PROBLEM POSSIBLE SOLUTION
The camera is not working
properly and the surface of the
camera case is hot.
The contrast on the screen is
too weak.
Is the camera connected to the proper power?
Adjust the contrast feature of the monitor.
Is the camera exposed to strong light?
If so, change the camera position.
ABCDEFGHIJ
KLMNOPQRST
UVWXYA 0123
456789 ( ) :
; . -
→← ! < > , '
←→ < > S E