5
-
Press S1 again to take the split time, “SPL” is flashing and the split time will be shown for 10 seconds on the
display, then the display will return to the current running time of the stop watch.
-
Press S2 to stop the stop watch.
-
If the heart rate zone is set to “on” after the stop watch is stopped, “Elapsed Time”, “Average Heart Rate”,
“Time in Zone” and “Calorie Consumption” will be displayed sequentially, each for 5 seconds. Press S2 to recall
the data one by one.
-
Press S1 to re-start the stop watch or press and hold S4 for 2 seconds to reset the stop watch and all stored
data back to zeros (“CLr” displayed).
Remarks:
1.
If no heart rate signal is received for 1 minute, the link between the watch and the transmitter will be cut off
automatically, and “- - -” will be shown on the display. To re-link, press S4, and “- - -” will start flashing or the
heart rate will be indicated
.
2. The heart rate measurement will not be taken when EL back light is “on” or alarm is sounding.
3. The resolution for the stop watch is 1/100-second for the first hour and 1 second for the rest. After 24 hours the
stop watch will stop automatically.
4. If the heart rate zone is set to “off”, there will be no zone alarm, high/low limit indication or “Time in Zone”
display.
5. “Average Heart Rate” = Sum of heart rates ÷ Number of samples.
6. “Time in Zone” is the time (excluding 1/100-seconds) that the heart rate stays within the high/low limit set.
7. The “Calorie Consumption” (shown in KCAL) depends on the weight, the heart rate of the user and the exercise
time.
8. If there is no heart rate signal received since entering the stop watch mode, “- - -” will be shown on the display.
The “Average Heart Rate”, “Time in Zone” or “Calorie Consumption” cannot be displayed.
7. Setting of time and chime
S1
S4
S2
S3
1 SECOND
AUTO
S2 or
S2 or
5 SEC
AUTO
5 SEC
AUTO
5 SEC
AUTO
5 SEC
AUTO
S2 or
S2 or
ELAPSED TIME
AVERAGE
HEART RATE
TIME IN ZONE
CALORIE
CONSUMPTION
S5
