6
07.16 207477 Rev.108
ROOF TOP UNITS
– AXIAL FAN
RMXCA/RMXCBA
RECEPTION
INSPECTION WHEN RECEIVING
• When the receiving the equipment, it is advisable to examine it carefully.
• Inspect the received equipment for damage or missing elements. If units are damaged or shipment is incomplete,
immediately file the claim with the shipping company.
• Check if unit nameplate voltage is correct and agrees with local power supply.
• In the case of detecting any damage or anomaly, it is recommended to contact HITECSA.
RIGGING
• Before moving the unit, make sure that all panels are well fixed and sturdy.
• Raise and lower the unit carefully
• Raise and set down the equipment carefully.
• During the transport never tip or roll the unit more than 15 degrees.
• To lift the unit, a crane can be used. Suggestions for the transport company are found below.
• When unit is being lifted, make sure it is balanced and stable, keep in mind that the heaviest part is where the
compressor is installed
• All units come with a proper rigging maneuver schematic, specific to that model of the Kubic series, to the likeness of
the one shown below.
STORAGE
• If the equipment must be stored before installation, certain precautions must be adopted to prevent damage, corrosion
or deterioration:
• Do not place the machine in areas exposed to ambient temperatures exceeding 40 ° C and preferably not give direct
sunlight.
• Minimum storage temperature is 8 ° C
• Maximum Relative Humidity: 90%
Fig.1
