6
7
5 x 4
Propellers
VTX Antenna
Arming Switch
2204-2330KV
Motor
LED Lights
FPV Camera
XT60 Battery
Connector
Video
Transmitter
Battery
PRODUCT LAYOUT (cont.)
DRONE
GETTING STARTED
Once you have unpackaged your Quad Racer 280 FPV drone, there are a few steps
to complete before you are ready to fly. You need to charge both the power battery
and the video monitor battery, attach the propellers, mount the video monitor
and set the channel on both the VTX and video monitor. The following section will
guide you through the processes. Please follow the directions carefully to ensure a
successful first flight.
CHARGING THE BATTERIES
Power Battery
The Quad Racer 280 includes a 3 Cell 2000 mAh power battery and the QRc3 AC
powered charger for charging it. Please use the following procedures in order to
safely and properly charge your power battery.
1. Plug the power cord into th charger and plug the other end into a 100-240V
wall socket. All LEDs will flash green and red indicating the charger is ready
to charge.
2. Insert the battery’s balance lead into the 3S charging port on the front of the
charger. After a couple of seconds, the charger will detect the voltage in the
battery and commence charging.
3. When charging, all 3 LEDs should be illuminated red. Once all 3 LEDs are
illuminated green, the charge process is complete.
NOTE: If you unplug the battery while charging, the charger stops automatically.
Charger
3S LiPoBattery
3S LiPo
Charge Port
Your connection should look like this when charging your battery
LED Indicator
Cause of Error
All LEDs flash red once in 1 second intervals
The battery is connected incorrectly
All LEDs flash red twice in 1 second intervals
There is an overload situation or short circuit
All LEDs flash red 4 times in 1 second intervals
The voltage of a single cell is too high or too low
All LEDs flash red 6 times in 1 second intervals
Indicates a 300mv voltage difference in the pack
Error Messages:
If the charger encounters a problem, all LEDs will flash red in some type of
sequence. If this happens, immediately disconnect the battery and AC power cord.
FPV Monitor Battery
(charger not included)
The FPV monitor contains an internal rechargeable battery that can be charged
using a Mini USB charger like those used for cell phones. An LED indicator light will
glow red while charging, changing to green when fully charged.
3 Cell Balance Port
2 Cell Balance Port
Cell 1 LED Indicator
Cell 2 LED Indicator
Cell 3 LED Indicator
100-240V
AC Input
LiPo CHARGER
