p14
p15
section 3
section 3
Installation Method:
(As shown below) Prepare two blades with gray caps and two with black caps. Attach the blades with gray
caps to the motor shafts without “P” marks and attach the blades with black caps to the motor shafts with “P”
marks. Tighten appropriate rotor blades as per the locking direction on blade.
quadcopter preparation
quadcopter preparation
Shooting Status Indicator:
When the quadcopter is turned on and the camera is used for recording and photo capture, the Shooting
Status Indicator will light up. Users can determine the current camera status through the Shooting Status
Indicator. Camera Status Indicators on the Transmitter are as shown in the figure below.
The Three LED Indicators on the Transmitter are:
1. Transmitter Power Indicator [red.]
2. Photo Capture Indicator [green.]
3. Video Recording Indicator [green.]
Function Status
Power Supply [Red]
Start Quadcopter
Accelerometer Calibration
Gyro Calibration
Compass Calibration
Remains ON
Remains ON
Remains ON
Remains ON
Start Video Recording
Stop Video Recording
Photo Capture
Photo Capture Completed
Low Power
Code-Pairing
GPS Satellite Searching
Remains ON
Remains ON
Remains ON
Remains ON
Remains ON
Remains ON
Remains ON
Photo Capture [Green]
OFF
OFF
OFF
OFF
OFF
OFF
Flash 0.3 sec
OFF
OFF
OFF
OFF
When the Transmitter battery charge is low, a warning alert sounds. When video recording and photo capture
commands are sent from the Transmitter, the Transmitter LED indicators show the corresponding function status.
Prepare Rotor Blades:
The Q-Cop 450 uses 10-inch rotor blades with black and gray color rotor blade caps. Rotor blades are
consumable items. If necessary, please purchase separately.
Rotor Blades
Install/Uninstall
Video Recording/Code-Pairing [Green]
ON>OFF
OFF
OFF
OFF
Slow Blink [1.5 sec OFF, 0.8 sec ON]
OFF
OFF
OFF
OFF
Remains ON
OFF
Grey Blade Lock: Turn Blade Clockwise
Grey Blade Unlock: Turn Blade Counter-Clockwise
Black Blade Lock: Turn Blade Counter-Clockwise
Black Blade Unlock: Turn Blade Clockwise
S1
S2
NULL
S3
S4
GPS
NRM
Rotor blades are designed for automatic turning, therefore do not tighten excessively during the installation.
Do not use glue. Please ensure rotor blades are installed in the correct position. The quadcopter cannot fly
properly if the rotor blades are installed incorrectly. Since the blades are very thin, it is advised to wear gloves
during installation to prevent accidental injury.
Summary of Contents for AEE Q-COP 450
Page 1: ......
