12
1. To avoid vibration and noise, make sure the unit is installed securely and firmly.
2. Install the unit where the sunlight does not shine directly on the unit.
If the unit receives direct sunlight, build an awning to shade the cabinet.
3. There should be no obstacle, such as a fence or wall, within 50cm from the back of the
cabinet because it will prevent heat radiation of the condenser.
Restriction of outside air will greatly reduce the cooling and heating efficiency of the
air conditioner.
4. Install the unit a little obliquely outward not to leak the condensed water into the room
(about 10mm or 1/4 bubble with level).
5. Install the unit with its bottom portion 75~150cm above the floor level.
6. The power cord must be connected to an independent circuit. The yellow/green
wire must be grounded.
Over 50cm
About 10mm
FENCE
AWNING
7
5
-1
5
0
m
m
Over 50cm
About 10mm
FENCE
AWNING
7
5
-1
5
0
m
m
All side louvers of the cabinet must remain exposed to the outside of the structure.
CAUTION
Select the best location
INSTALLATION INSTRUCTIONS
For Reverse Cycle Models:
You can choose bottom drainage . See the following
procedures to perform bottom drainage:
1. Take out the drain pan and screws (which provided with
your air conditioner accessory).
2. Install the drain pan at the bottom of the unit and
secure with screws provide.
3. Connect the drain hose to the outlet located at
one side of the drain pan. You can purchase the
drain hose or tubing locally to satisfy your particular
needs (Drain hose is not supplied)
RUBBER
PLUG
SCREW
DRAIN PAN
DRAIN
OUTLET
Summary of Contents for WINDOW/WALL TYPE ROOM AIR CONDITIONER
Page 18: ...CS267 U ...