--- 21 ---
Push down.
Retaining Ring
[2]
Washer (D)
[3]
J-295 jig (B) for retaining ring
J-295 jig (A) for retaining ring
Fig. 12
(5) Reassembly of the Guide Sleeve
[5]
Insert the Steel Ball D3.5
[8]
into the hole of Anvil (B)
[9]
. Mount the Guide Sleeve
[5]
, the Guide Spring
[4]
and Washer (D)
[3]
in sequence. Mount the Retaining Ring
[2]
into the groove of the anvil using J-295 jigs (A)
and (B) for retaining ring as illustrated in Fig. 12.
(6) Reassembly of the Hook Ass'y (W/Light)
[35]
Check that the V-Lock Nut M5
[37]
is mounted to the Hook Ass'y (W/Light)
[35]
. Then mount the Hook Spring
[42]
and secure it with Special Screw (A) M5
[43]
. (Mount the Hook Spring
[42]
with its larger-diameter side
pointing toward the inside of the housing.)
(7) Check whether the direction of rotation of Anvil (B)
[9]
coincides with the directional markings on the push-on
side of the Pushing Button
[33]
. When the Pushing Button
[33]
is turned to the (R) side, the direction of
rotation of Anvil (B)
[9]
should be clockwise, as viewed from behind.
(8) Lubrication
(a) ATTOLUB MS No. 2
Cam groove and sliding section of Spindle (B)
[17]
Cam groove and projection of the Hammer
[11]
8 mm diameter hole and oil groove and upper surface of the claw of Anvil (B)
[9]
Sliding section between Anvil (B)
[9]
and the metal
Two Steel Balls D5.556
[10]
Pinion tooth flanks and front metal of the Motor
[26]
Tooth flanks of the Ring Gear
[20]
Twenty-eight Steel Balls D3
[12]
Needle Roller
[19]
Tooth flanks and 5 mm diameter hole of the Idle Gear Set
[18]
(b) HITACHI MOTOR GREASE No. 29
Steel Ball D3.5
Sliding section of Anvil (B)
[9]
and the Guide Sleeve
[5]
