--- 17 ---
Anvil (B)
[9]
Retaining Ring
[2]
Washer (D)
[3]
Guide Sleeve
[5]
Gap of retaining ring
1
Fig. 7-1
Hold the body and adjust gap of the retaining ring to
groove of anvil (B), then insert a small flat-blade
screwdriver into the groove at an angle.
2
Fig. 7-2
Press down washer (D) with the screwdriver.
3
Fig. 7-3
Slide the screwdriver under one side of the gap of
the retaining ring.
4
Fig. 7-4
Slowly raise the retaining ring using the end face of
the guide sleeve as a fulcrum.
Then slowly raise the other side of the retaining ring with a screwdriver until it is free. The Guide Sleeve
[5]
can
now be removed. Avoid quickly raising the retaining ring or it may fly out forcefully.
The retaining ring can also be easily removed by widening the gap of the retaining ring with the jig for retaining
ring and slowly raising the retaining ring with a small flat-blade screwdriver.
(7) Disassembly of the hammer assembly
Hammer
[11]
Push down.
Spindle (B)
[17]
Hammer Spring
[14]
Stopper
[16]
Washer (S)
[15]
J-297 Base
for washer (S)
Fig. 8
Mount the hammer assembly onto the J-297
base for washer (S).
With a hand press, push down the top of
Spindle (B)
[17]
to compress the Hammer
Spring
[14]
. In this position, remove the
Stopper
[16]
with a flat-blade screwdriver,
then release the hand press. (See Fig. 8.)
Small flat-blade
screwdriver
