Getting Started (Initial Setup)
- 27 -
7, 0, 8, 9, and 6 to get 07/08/96.
When you're done, press GUIDE to return to regular viewing.
Tips:
The white dash " - " appears for the item to be changed on the screen as you
proceed.
The clock uses the 12-hour system. You set it for AM or PM.
An illogical time (like 13 for the hour or 20 for the month) will not be accepted.
If you press the wrong digit, exit the screen by pressing GUIDE and recall the screen
to enter the correct setup.
The day of the week is set automatically.
More about Channel Selections
Your VCR is capable of receiving 68 broadcast TV channels (VHF 2-13, UHF 14-69)
and 125 cable channels (CATV 1-125).
1. Press GUIDE, then press 4 to bring up the CHANNEL PRESET screen.
2. Press 1 to select the type of receiving setup you have.
Each time 1 is pressed, the option for "1 CHANNEL" switches from <CATV1> to
<ANT>, <CATV2> and back to <CATV1>.
<CATV1>: Ordinary
cable
<ANT>:
Internal or external antenna.
<CATV2>:
Alternate cable (if <CATV1> doesn't give you the channels you expect).
3. Press 2 to select "2 AUTO CHANNEL SET". The tuner automatically cycles through
all available channels in your area and place them in memory. This takes 2-3 minutes.
After the channels are stored in memory, the channel with the lowest number appears in
the VCR's display. Press GUIDE to return to regular viewing.
For convenience, the TV channel numbers should match those programmed into the
VCR. If your TV has automatic channel programming, set it on the same mode -
CATV1, ANT, or CATV2 - and let it reprogram to match the VCR.
Once channels are preset, you can use the up and down CHANNEL buttons to move
through the active channels. Or you can press the number buttons to move quickly
between channels that are far apart.
Removing Channels
You may not want to keep all the stations the auto-programmer selects, since you may
prefer to have only a few favorite channels in the tuner's memory. Or, you may want to
delete from memory a weak or unused channel that the tuner picked up.
Erased channels cannot be selected by the up and down CHANNEL buttons but can
still be selected by using the numbered buttons 0 to 9 and 100/ENT.
Adding Channels
Occasionally the auto-programming may skip an active channel because the antenna
was pointed in the wrong direction or the channel had a weak signal or was "off the air"
at the time of programming. Or you may change your mind about a channel you
removed from memory.
To Add or Erase Channels
Press GUIDE, then press 4 to bring up CHANNEL PRESET screen. Item 3 lets you
Summary of Contents for VT-UX605A
Page 4: ...FOR YOUR SAFETY 4 ...
Page 64: ...Advanced Operations Stereo System 64 PLAY ...
