15
INSTALLING THE BATTERIES
1 ) Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.
2) Insert 2 "AA" penlight batteries into the battery compartment in the direction indicated by the polarity (+/-)
markings.
3) Replace the cover.
You can program the tuner to scan only the channels you receive in your area. You must use the remote control for this
procedure.
NOTES:
• Channel memory programming is NOT needed when connected to a cable box or satellite box as in Fig 4 on
page 11 or Fig 5 on page 12 In this case with your remote, select the VCR to channel 3 or 4 the same channel as
located on the back of VCR (CH3 or CH4). Then the channel you wish to record or view may be selected on the
cable box or satellite box.
• Follow the steps below once. Repeat only if there is a power failure or if the VCR is unplugged for more than 30
seconds. (In these cases, the programmed channels are erased.)
• You must follow the steps below before attempting to play or record a video tape. If you want to play or record a
video tape BEFORE programming the tuner, you must first turn off the VCR. Then, press the POWER button again to
turn it back on. To program the tuner again, see "CHANNEL SET UP AGAIN" on page 16.
Summary of Contents for VT-MX4510
Page 20: ...20 ...
