INSERTING AND REMOVING CASSETTES
- 16 -
NOTES:
• If the erase prevention tab on the cassette is removed, the
"TAPE"
indication in the viewfinder flashes for
several seconds and the camcorder will not enter record/pause mode.
• See page 8 for
"EYEPIECE ADJUSTMENT"
.
4. Now, press
"REC/PAUSE"
to start shooting the picture. The
"REC"
indication appears in the viewfinder and
you are now recording the picture you see through the viewfinder.
5. Press
"REC/PAUSE"
to stop recording. Press the button again to resume recording. The " " indication will
appear in the viewfinder instead of
"REC"
while the camcorder is in the record/pause (stand-by) mode.
NOTES:
• The
"TAPE END"
indication starts flashing in the viewfinder when there is about five minutes recording time
left on the cassette.
• If the record/pause mode continues for more than 5 minutes, the camcorder's power is automatically turned off.
To turn on again, press
"REC/PAUSE"
. The camcorder enters record/ pause (stand-by) mode.
6. Slide
"CAM/OFF/VIDEO"
to
"OFF"
position to turn off the camcorder.
7. Press
"STOP/EJECT"
to remove the cassette.
8. Always remove the power source from the camcorder after use.
NOTE:
If you have a cassette tape that has already been partially recorded on and you want to record the
remaining blank section, see "QUICK EDIT" on page 27.
INSTANT REVIEW
1. In record/pause (stand-by) mode, tap
"REW/ REVIEW"
, and the last few seconds of the recorded scene is
