29
SETUP OPERATION (continued)
How to Use the Macro Buttons
Press the TV mode key on the R/C.
•
Press and hold the TV mode key and enter
•
the following sequence “9,7,8”.
Select the macro key that you would like to
•
clear (M1,M2,M3,M4).
Press the same Macro key that you select
•
to clear.
The R/C will return to normal state and the
•
TV mode LED will turn off.
NOTE
If no Macro steps are entered within 10
seconds while the R/C is in Macro learning
state, the R/C will automatically return to it’s
normal state.
Backligthing is not available when the R/C is in
it’s macro learning state.
Please remember that last R/C Mode key that
was pressed during a Macro setting it will be
the mode where the R/C continue to operate;
to end correctly, press the TV mode to your
macro sequence.
How to Clear a Macro key
MACRO Buttons
This optional feature allows the user to record a sequence
of keys conveniently operate multiple devices with one key
press. The Macro can only be created on the control’s TV
mode.
Select TV mode by pressing the
1.
button.
Hold down the
2.
button on the remote and enter the
digits “9”, “7”, “8” in sequence.
The TV mode LED will come on and remain on to signal
3.
that the macro learning state is ready, if not please try
again step 2.
Select one of the Macro keys (M1,M2,M3,M4) that the
4.
Macro will be setup on.
Enter the key sequence that the Macro steps will include
5.
(up to 10 keystrokes per Macro). To enter a delay
between steps the user should press the current mode
button ( TV, DVD, PVR, SAT, AVR).
After all macro steps are entered press the same Macro
6.
key that was pressed (M1,M2,M3,M4).
The remote will return to it’s normal state and the TV
7.
mode LED will turn off.
Upon entry of an invalid key sequence, the R/C shall
8.
display a 1-second long blink and return to normal
operation. An invalid sequence is recognized as a key
press that is not a Macro key (M1,M2,M3,M4) after step
3.
A macro will overwrite the previous macro if one was
9.
already programmed.
MACRO SETUP EXAMPLE (Power ON , Monitor, DVD
player and Audio Device)
Press TV mode on the R/C.
Enter the sequence “ 9,7,8” buttons of the R/C..
Check if in Macro Learning Mode (TV mode LED is on).
Press the Macro button “M1” of the R/C.
Press the POWER button.
Press the DVD mode key.
Press the POWER key.
Press the AVR mode key.
Press the POWER key.
Finally press the Macro button “M1” to complete the
macro capture. The R/C will return to it’s normal state
and the TV mode LED indicator will turn off.
(In order to turn ON the devices, the External Device
Control Setup for each mode have to be done first,
please refer to pages 31 and 32 for the R/C codes.)
