3-10
StarBoardLink EZ
How to use
English
If the positions of the pen tip and cursor are out of alignment, select "MENU" on the StarBoard
Software toolbar
→
"Settings"
→
"StarBoard"
→
"Calibrate," and then perform position
alignment.
3.4.2 Start Method (Mac version)
(1) Connect the USB cable of digitizer to the computer.
(2) Turn on the power switch of the projector.
(3) Turn the computer power switch on to startup Mac.
(4) Adjust the position of the projector so that the Mac screen projected by the projector is
within the input area (refer to page 1-4 of this User's Guide).
(5) Select "Go"
→
"Applications"
→
"StarBoard Software" to start StarBoard Software.
(6) Select "MENU" on the StarBoard Software toolbar
→
"Settings"
→
"StarBoard"
→
"Check Connection," and then check the connection.
If the "StarBoard is not connected" message appears, StarBoard Software has not detected
the StarBoardLink EZ. Check whether the StarBoardLink EZ and PC are connected
properly.
Connected No
Connection
If they are connected properly, the "StarBoard is connected" message appears. If the
indication does not change even though you have checked the connection, there is likely to
be some problem. For details, see "4. Appendix Troubleshooting" on page 4-1 in this user's
guide.
Important
Run the “StarBoardLink EZ Setup Wizard” when operated for the first
time, and whenever the board is moved.
Not doing so may cause operation errors.