1-13
StarBoard FX-79E1/89WE1
Introduction
English
[3] Adjust the height
Install the board on the stand assembled in step (1). Install the board according to the
following procedure. Furthermore, this step should be performed by at least two people.
Numbers in the diagram correspond to numbers in the parts list on page 1-3.
(a) Decide the level (out of six) at
which the board will be installed,
and use the square holes on the
back of the board to hang it on the
Height Adjustment Stay.
(b) Verify that one of the board’s
square holes is attached securely to
the Height Adjustment Stay on
each side.
(c) Tighten triangular knob screw to
fasten the board to the board fixing
bracket on each side.
[4] Adjust the height
The StarBoard can be positioned at six height levels. Adjust the height according to the
following procedure. Furthermore, this work should be done by at least two people.
(a) Loosen the screws shown in (5) in the
figure on page 1-9.
(b) Lift the board to the installation height.
(c) Tighten the screws shown in (5) with a
spanner.
(a)(c)
(b)
Board
(6)
(10)
(4)(5)
