II
SAFETY SUMMARY
● Use the specified non-flammable refrigerant to the outdoor unit in the refrigerant cycle. Do not charge material other than
specified refrigerant into the unit such as hydrocarbon refrigerants (propane or etc.), oxygen, flammable gases (acetylene
or etc.) or poisonous gases when installing, maintaining and moving. These flammables are extremely dangerous and
may cause an explosion, a fire, and injury.
● Do not pour water into the indoor or outdoor unit. These products are equipped with electrical parts. If poured, it will
cause a serious electrical shock.
● Do not touch or adjust safety devices inside the indoor or outdoor units. If these devices are touched or readjusted, it
may cause a serious accident.
● Do not open the service cover or access panel for the indoor or outdoor units without turning OFF the main power
supply.
● Refrigerant leakage can cause difficulty with breathing due to insufficient air. Turn OFF the main switch, extinguish any
naked flames and contact your service contractor, if refrigerant leakage occurs.
●
The installer and system specialist shall secure safety against refrigerant leakage according to local regulations or
standards.
● Use an ELB (Electric Leakage Breaker). In the event of a fault, there is danger of an electric shock or a fire if it is not
used.
● Do not install the outdoor unit where there is a high level of oil mist, flammable gases, salty air or harmful gases such as
sulphur.
● Do not use any sprays such as insecticide, lacquer, hair spray or other flammable gases within approximately one (1)
meter from the system.
●
If circuit breaker or fuse is often activated, stop the system and contact your service contractor.
● Do not perform installation work, refrigerant piping work, drain piping and electrical wiring connection without referring to
our installation manual. If the instructions are not followed, it may result in a water leakage, electric shock or a fire.
● Check that the ground wire is securely connected. If the unit is not correctly grounded, it lead electric shock. Do not
connect the ground wiring to gas piping, water piping, lightning conductor or ground wiring for telephone.
● Connect a fuse of specified capacity.
●
Do not put any foreign material on the unit or inside the unit.
● Make sure that the outdoor unit is not covered with snow or ice, before operation.
● Before performing any brazing work, check to ensure that there is no flammable material
●
around.
When using refrigerant be sure to wear leather gloves to prevent cold injuries.
● Protect the wires, electrical parts, etc. from rats or other small animals.
If not protected, rats may gnaw at unprotected parts and which may lead to a fire.
● Fix the cables securely. External forces on the terminals could lead to a fire.
Summary of Contents for RPK-0.8HNBUSQ
Page 2: ......
