21
Installation
15.3 Mounting the Indoor Units
Hook the indoor unit to the mounting bracket, maintaining the
indoor unit upright.
Hook
Hook
Mounting
Bracket
Catch
Slowly hold up and
press the unit downward.
Check to ensure that the unit is completely hooked
onto the mounting bracket. If not, it may drop from
the bracket, resulting in a serious accident.
(1)
The side of the drain pipe is downward-sloping 2
degrees or 3 degrees in the process of the unit
installation.
(2) Check the drainage of the drain pan through water
overflow test.
Fig. Slop Angle of the Indoor Units
(2) Pay attention to the junction of grille from each side, to
prevent breaking off.
15.4 Removing Flat Panel
In order to connect the refrigerant piping, wiring and
to check drain water flow, removing the flat panel is
needed. Perform these work according to the following
instructions. Pay attention to the resin components not
to scratch.
(1)
Hold both sides of the flat panel and open it, and pull
the right arm toward the inner side. Slightly close the
flat panel and pull it, then remove the flat panel.
Flat Panel
Summary of Contents for RPK-0.8HNBUSQ
Page 2: ......
