37
Maintenance (P.16
〜
19)
Maintenance of the outer blade and inner blade (P.17)
Be sure to turn the switch to "OFF." (Cause of injury to fingers)
1. Turn the switch to "OFF," and remove the outer blade holder.
2. Clean the outer blade, inner blade, and body.
3. Install the outer blade holder.
Maintenance of the trimming blade (P.18)
1. Turn the switch to " " and pop up the trimming blade.
2. Lightly hold the trimming blade from below, and turn the switch
to "OFF."
3. Clean the trimming blade and body.
4. After cleaning, push down the trimming blade with a finger.
Wipe away any contamination of the body with a cloth wrung
tightly after being moistened with water or watered-down kitchen
detergent (neutral).
Note : Do not use alcohol, benzine, thinner, etc.
(Cause of deformation or discoloration)
How to replace the outer blade and inner blade
(P.20
〜
22)
Be sure to turn the switch to "OFF." (Cause of injury to fingers)
Never hold the outer blade strongly.
(Breakage causes damage to fingers.)
How to replace the outer blade (P.20)
1. Turn the switch to "OFF," and remove
the outer blade holder.
2. Remove the outer blade while pressing it
slightly from the exterior.
Spray lubricant sold separately (shaver cleaner) to the outer blade
and trimming blade at least once a week, idle for approximately 10
seconds, and wipe the surface of the blade.
After replacing the outer blade and/or the inner blade, make sure to
spray lubricant sold separately (shaver cleaner).
(Cause of stoppage of the inner blade operation, reduction in
rotational speed, etc.)
Pull.
While pressing
the outer blade