13.5 ELECTRICAL WIRING
!
C A U T I O N
• Perform securely the electrical wiring work. If the electrical work is not completed, heat generation at the connection, a fire or an electric shock
may occur.
• Make sure that the wires are securely fixed in order not to apply an external force to the terminal connections of the wirings. If fixing is not
completed, heat generation or a fire will occur.
1
The following connectors are used in the air panel. Remove the tape fixing the wiring connectors on the air panel and pull out
them as shown in the figure below. Connect them with the wiring connectors to CN17 in the electrical box as the following figure.
ON
1 2
ON
1 2
CN17
Air panel
PCB
Cable for auto swing motor
Connector
(CN17)
Earth screw
Electrical box
Indoor unit
Wire clamp
Control cable
Remote control switch cable
Power source cable
?
N O T E
Before the electrical wiring work, turn OFF the power source. If the connectors are connected without turning OFF the power source, the auto swing
louver can not activate.
2
After completing the wiring connection of the air panel, attach the air inlet grille. Perform the attaching work in the reverse
procedure of removing. Refer to item 3 of the section
"13.4 Installation".
Hook the swivel of the supporting string at
Ⓐ
to the hole
at the air panel. The air inlet grille can be attached from any 4 directions by rotating it. When multiple indoor units are installed or
requested from a user, the air intake grille direction can be selected freely.
Supporting string
Hole at air panel
Ⓐ
Part
INSTALLATION OF OPTIONAL AIR PANEL
PMML0550 rev.0 - 12/2020
25
EN
