1
1
.
.
O
O
P
P
T
T
I
I
O
O
N
N
L
L
I
I
S
S
T
T
Parameter setting
The wired controller room temperature display and limit set temperature can be revised if needed.
Before setting, please check if these parameters are enabled to be revised, for details,
see
Custom parameters
.
1
.
Temperature limit setting
Default temperature set point range is (16-30)
℃
. You can change the range when needed. For
example, in cooling mode, temperature adjustment range could be changed to (23-30)
℃
; in
heating mode, it could be changed to (16-23)
℃
. The temperature limit is only effective for the
cooling and heating modes.
Temp. limit setting (cooling mode)
Temp. limit setting (heating mode)
Room temperature correction
How to quit:
Press the " " button to exit without settings.
2
.
Room temperature correction
Setting room temperature correction is for particular cases (e.g. remote located at an area with
different temperature
from
the room) : wired controller is set to display room temperature, but
the room temperature detected is different from the actual room temperature, so setting
correction is necessary.
Room temperature correction value
1
2
3
4
Setting method:
Press and hold the " " and " " button at the same time for 5s to enter parameter setting mode.
Press " " or " " until room temperature icon " " and temp. value start blinking on the screen,
and press " " to enter room temp. correction mode.
Press the " " or " " button to adjust the room temperature value within an offset of ±10
℃
of the
current temperature.
Press the " " button to confirm the setting, save the setting and exit.
3
1
1
2
3
4
5
6
Setting method:
the " " and " " button at the same time for 5s to enter paramet
Press down the "
Press down
Press "
" or " "
button
until set temp. icon " " cooling mode icon " " and temp
.
all values
blink on the display, press " " to enter cooling temp. limit setting mode.
Press the " " or "
Press the " " or "
" button to adjust the lowest coo
ling temperature value.
Press the " " button to confirm the setting and enter heating temp. limit setting mode,
temp. icon
" " heating mode icon " " and temp. all values will blink on the display.
Press the " " or " " button to adjust the highest heating temp. value.
Press the " " button to confirm the setting, save the setting and exit.
