--- 7 ---
Fig. 6
7-2. Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
[13]
[14]
Fig. 8
Fig. 7
[19]
[15]
[14]
(1) Mount Washer (A)
[14]
to the Armature
[15]
so that the convex side of Washer (A)
[14]
faces the ball bearing.
Press-fit the Ball Bearing 608DDW
[13]
as far as it will go.
(2) Check that the Bearing Lock
[12]
is mounted to the ball bearing chamber of the Housing Ass'y
[20]
. Then put
the Armature
[15]
in the Stator Ass'y
[18]
.
(3) Check that the Bearing Lock
[12]
is mounted to the Casing
[8]
. Secure the Casing
[8]
to the Housing Ass'y
[20]
with the Tapping Screws (W/Flange) D5 x 30
[10]
.
(4) Mount the Washer
[11]
to the armature shaft. Insert the Fan
[7]
aligning with the width across flat of the
armature shaft and secure it with the U-Nut M6
[6]
. The tightening torque of the U-Nut M6
[6]
is 2.9 0.5 N
•
m
(30 5 kgf
•
cm). Be careful not to overtighten the U-Nut M6
[6]
.
(5) Secure the Casing Cover
[5]
to the Casing
[8]
with two Tapping Screws (W/Flange) D4 x 20 (Black)
[9]
and
four Tapping Screws (W/Flange) D4 x 25
[35]
. Be careful not to mistake the screw positions.
Tapping Screws
(W/Flange) D4 x 20 (Black)
[9]
Tapping Screws
(W/Flange) D4 x 25
[35]
(6) Mount the Carbon Brushes (1 Pair)
[28]
to the Housing Ass'y
[20]
.
Ball bearing side
Washer (A)
[14]
