TC-12001
2-105
OUTDOOR UNIT
P5414950-rev.1
29
7.
Electrical Wiring
O
The electrical wiring work must be performed by authorized installers. If not performing the
electrical work completely or a capacity shortage of the power circuit, it may cause an electric
VKRFNRU¿UH
O
Perform the electrical work according to each regulation of region and “Installation & Maintenance
Manual” of the outdoor unit, and the dedicated electrical circuit must be utilized. If not performing
the electrical wiring work completely or a capacity shortage of the power circuit, it will cause an
HOHFWULFVKRFNRU¿UH
O
8WLOL]HWKHVSHFL¿HGFDEOHVIRUZLULQJEHWZHHQWKHRXWGRRUXQLWDQGWKHLQGRRUXQLWV6HOHFWLQJ
LQFRUUHFWFDEOHVZLOOFDXVHDQHOHFWULFVKRFNRU¿UH
O
Turn OFF the main power switch to the indoor unit and the outdoor unit and wait for more than
3 minutes before electrical wiring work or a periodical check is performed.
O
Check to ensure that the indoor fan and the outdoor fan have stopped before electrical wiring work
or a periodical check is performed.
O
Protect the wires, electrical parts, etc. from rats or other small animals.
,IQRWSURWHFWHGUDWVPD\JQDZDWXQSURWHFWHGSDUWVDQGZKLFKPD\OHDGWR¿UH
O
Avoid the wirings from touching the refrigerant pipes, plate edges and electrical parts inside the
XQLW,IQRWGRWKHZLUHVZLOOEHGDPDJHGDQGDWWKHZRUVW¿UHZLOORFFXU
.
O
Use a medium sensing speed type ELB (Earth Leakage Breaker, activation speed of 0.1 sec. or
OHVV,IQRWXVHGLWZLOOFDXVHDQHOHFWULFVKRFNRU¿UH
O
)L[WKHFDEOHVVHFXUHO\([WHUQDOIRUFHVRQWKHWHUPLQDOVFRXOGOHDGWR¿UH
O
Tightly clamp wires by the cord clamp after the wiring is completed to the terminal board. In
DGGLWLRQUXQVHFXUHO\ZLUHVWKURXJKWKHZLULQJKROH,IQRWFRPSOHWHGLWPD\FDXVH¿UHE\ELWLQJ
wires.
O
Tighten screws according to the following torque. If tightening work is not completed, it may cause
KHDWJHQHUDWLRQDQHOHFWULFVKRFNRU¿UH
M4:
1.0 to 1.3 N-m
M5:
2.0 to 2.4 N-m
M6:
4.0 to 5.0 N-m
M8:
9.0 to 11.0 N-m
M10: 18.0 to 23.0 N-m
Summary of Contents for RAS-3HVRNM2
Page 58: ...2 130 TC 12001 ...