10-1
10 OPTION LIST
10.1 WIRED REMOTE CONTROL
10.1.1 SHIFT VALUE
1. Press and hold
(ON/OFF) button and
(ON TIMER) button at the same time while giving a single press on
the RESET button until remote controller now enter ‘Shift value change mode’.
2. Press
(ON/OFF) button so that the display indicates
(FAN) speed.
3. Select
(FAN SPEED) button to choose Heating Shift or Cooling Shift Mode.
By setting fan speed to HIGH
or MED
, it will go to Cooling Shift mode.
By setting fan speed to LOW
or SILENT
, it will go to Heating Shift mode.
4. Press
(ROOM TEMPERATURE) button to change the shift value (-3
°
C ~ 0 ~ 3
°
C).
5. Press
(ON/OFF) button to end ‘Shift value setting mode’.
NOTE:
1. There are total of 7 shift values ranging from -3 to 3.
2. The changed shift value will remain unchanged after turned off the power.
RAR-5G2 (SPX-RCDB)
BUTTONS
FUNCTION
MODE Selector
Use this button to select the operationg mode. Every time you press this button,
the mode will change from
cyclically.
FAN SPEED Selector Button
This determines the fan speed. Every time you press this button, the airflow
rate will change from
(This button allows selection of optimal or preferred fan speed for
each operation mode).
ON/OFF button
Press this button to start operation. Press it again to stop operation.
SLEEP button
Use this button to set the SLEEP timer.
SET button
Timer setting reservation.
OFF button
Select the turn OFF timer.
ON button
Select the turn ON timer.
CANCEL button
Cancel timer reservation.
AUTO SWING (Vertical) button
Controls the angle of the horizontal air deflector.
ROOM TEMPERATURE setting button
Value will change quicke when keep pressing.