Hitachi RAC-50WXA, Operation Manual, Page: 31 / 281

– 3 1 –
ENGLISH
INFO FUNCTION
ƽ
By pressing (INFO) button, temperature around remote controller and monthly power consumption
will be displayed on the remote controller.
ƽ
After changing the batteries, direct the remote controller towards the indoor unit and press (INFO)
button.
Current calendar and clock will be transmitted from indoor unit.
ƽ
In order to receive information from indoor unit, the distance between remote controller and receiver of indoor
units is within 2 meters.
Ƶ
To check temperature around remote controller
Ƶ
Current calendar and clock can be retrieved
from indoor unit
Ƶ To check monthly power consumption
Press (INFO) button.
Temperature will be displayed for 10 seconds.
Direct the remote controller towards the receiver of indoor unit (within 2
meters in front of indoor unit) and press (INFO) button. Wait
for 2 seconds for signal transmission.
Once received the current calendar and clock, check whether they
are correct or not by pressing
(CLOCK) button.
ƽ
If there is no power supply to indoor unit or calendar and clock
have not been set, INFO function cannot be used for sending or
receiving information.
Direct the remote controller towards the receiver of indoor unit (within 2
meters in front of indoor unit) and press (INFO) button. Wait
for 2 seconds for signal transmission.
While temperature around remote controller is displayed,press
(INFO) button repeatedly. The display will show as below:
this month power consumption amount for heating last month
power consumption for heating this month power consumption
amount for cooling last month power consumption amount for
cooling temperature around remote control this month power
consumption amount for heating ...... cyclically.
ƽ
If indication is not given, bring remote controller closer to the
receiver of the indoor unit.
ƽ
lndicated value shall be regarded as a guide only.
1
NOTE
ƽ
In case failure occurs to the air conditioner, by pressing (INFO) button, an error code will
be displayed.
Direct the remote controller towards the receiver of indoor unit (within 2 meters in front of indoor unit)
and press (INFO) button. Wait for 2 seconds for signal transmission.
An error code will be displayed.
Call service center and inform the error code.
AIR PURIFYS