– 7 –
RESET
AUTOMATIC OPERATION
The device will automatically determine the mode of operation COOL, or Dehumidify, depending on the
initial room temperature. The selected mode of operation will not change when the room temperature
varies.
■
As the settings are stored in memory in the remote controller, you
only have to press the
(START/STOP) button next time.
Press the FUNCTION selector so that the display indicates
the
(AUTO) mode of operation.
●
When AUTO has been selected, the device will
automatically determine the mode of operation COOL or
Dehumidify, depending on the initial room temperature
and outdoor temperature.
Press the
(START/STOP) button.
Operation starts with a beep.
Press the button again to stop operation.
You can raise or lower the temperature setting as necessary by
maximum of 3
°
C.
Press the temperature button and the
temperature setting will change by 1
°
C each
time.
●
The preset temperature and the actual room temperature may
vary somewhat depending on conditions.
●
The display does not indicate the preset temperature in the
AUTO mode. If you change the setting, the indoor unit will
produce a beep.
1
■
CONDITION OF AUTOMATIC OPERATION
START
STOP
Over 27
°
C
COOL
16~27
°
C
TEMPERATURE
SETTING
FUNCTION
27
°
C
HIGH at start, LOW after
the preset temperature is
reached.
-
DEHUMIDIFY
-
INITIAL ROOM
TEMPERATURE (APPROX.)
FAN SPEED
Slightly lower than the
room temperature
LOW
●
The selected mode of operation will not change during the operation even though the room temperature
change.
(EN2) RAS/RAC-260/350GA
18/1/06, 10:12 AM
7
