Hitachi RAC-25WXA, Instruction Manual

Page: 9 / 40

– 9 –
ENGLISH
R E MOT E CO N TRO LLE R
ƽ
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting is
controlled electronically, the range of control may be shorter.
be controlled from the remote controller.
ƽ
Handle the remote controller with care. Dropping it or getting it wet may compromise its signal transmission
capability.
ƽ
After new batteries are inserted into the remote controller, the unit will initially require approximately 10
seconds to respond to commands and operate.
ƽ
When remote controller is not in use for about 3 minutes during OFF condition, indicated by on the
display, the LCD will turn off.
ƽ
During clock setting, the LCD will turn off about 10 minutes later if the remote controller is not in use.
ƽ
When pressing any button, the LCD will turn on.
ƽ
The LCD will not turn off during TIMER setting.
S ignal Transmitting/Receiving
Window
Point this window towards the
indoor unit when controlling it.
S ensor
A temperature sensor inside the
remote controller senses ambient
temperature around the remote-
controller.
Display
This indicates the room temperature
selected, current time, timer status,
function and airflow rate selected.
ROOM T E MP E RATUR E setting Buttons
Press these buttons to set the room
temperature.
Press the [ ] button to raise the room
temperature.
Press the [ ] button to lower the room
temperature.
Keep pressing and the value will change
more quickly.
E CO Button
Use this button to set the ECO
S TART/ S TOP button
Press this button to start
operation. Press it again to stop
operation.
FA N S P EE D selector Button
This determines the fan speed.
Every time you press this button,
the ange from
(AUTO) (HIG H )
(MED) (LOW)
(SILENT) (This button allows
optimal or preferred
fan speed for each operation mode).
Transmission sign
The transmission sign lights up
䇆
䇆 䇆
䇆
NAMES AND FUNCTIONS OF REMOTE
when a signal is sent.
airflow rate will ch
selection of
CONTROLLER
ler
mode.( p.19 )