Hitachi RAC-08PH1, Service Manual, Page: 105 / 114

1. Front Panel
(1)Pull up the washable panel by holding it at both
lower sides with both hands.
Fig. 1
(2)When the panel opens full, push the inner part
of the right arm into the inside and pull the panel
forward while closing it gradually.
Fig. 2
2. Front cover
Fig. 3
Indicating P.W.B.
Control P.W.B.
Support hook
3. Control P.W.B. and Indicating
P.W.B.
(1)Remove each connector from the lead wire.
(2)Remove the four P.W.B. supports from the
control P.W.B.
( 3 )Pull the support hook at the upper side of the
indication lamp of the indicating P.W.B. and pull
out the P.W.B. forward.
Fig. 4
Procedure for Disassembly and Reassembly
INDOOR UNIT RAS-08P H 1,RAS-10P H 1, RAS-14P H 1
7(0325$5<
6:,7&+
105
securely. Then, push the center of the front
cover to loc k the claws.
(1) C hec k that the drain pan is securely attached.
(2)After installing the front cover onto the unit,
( 3 )Tighten the two screws.
hoo k three claws at upper side of the cover