61
Set the condensation prevention heater to MIN.
(Swing partition)
Setting the condensation prevention heater to MIN saves energy.
When dew is formed in the swing partition, set it to the standard.
The temperature settings for the swing partition can be adjusted by three levels (1 to 2), and level 2 is the most energy saving.
MIN setting of the heater
Standard
MIN setting level 1
MIN setting level 2
Standard
Preset sound
−
Long beep
Long beep (2 beeps)
2 beeps
Open the door of the Lower Freezer Compartment.
Touch
button on the Control Panel to turn on the indicator lamp.
All indicator lamps turn on, and then the current settings are displayed.
Close the door of the Lower Freezer Compartment.
Press down
button for 3 seconds or more until the preset sound is heard.
The setting of MIN level of the dew condensation prevention heater will be switched.
Repeat the above-stated operation to set it to the level you prefer (see the table above).
1
2
4
3
●
The setting will be returned to the standard when the power plug is disconnected and connected or power failure recovery takes place.
Notice
(At the time of purchase)
Setting “Energy Saving” mode
Setting the “Energy Saving” mode reduces the ability to cool each compartment for energy savings.
Likewise, when the door of the Vegetable Compartment is left open for 30 seconds or more, the LED light in the compartment has reduced brightness for
energy savings.
If a door is not opened or closed for a long time,
the inside is cooled down slowly to further reduce power consumption.
●
Automatic temperature control lowers cooling loads, which may cause ice cream to get soft and frost to form
on frozen food. It also requires longer freezing time and ice making time.
●
When “Quick” , “Quick Freeze” and “Spot Cool” is set in the Energy Saving mode, the Energy Saving mode is temporarily
cancelled.
●
When both “Save” and “Veg” modes are set concurrently, the cooling function will be weakened from the “Veg” .
Pg.56
●
When the temperature of the “Freezer Compartment” and/or “Refrigerator Compartment” is set to “
■
” , the minimum level of
cooling is not reduced to maintain the freshness of foods.
●
When “Spot Cool” is set while “Save” is set, the wekening of the cooling function will be temporarily canceled if food is detected.
Notice
Touch
button to turn on the “Save” indicator lamp.
The Energy Saving mode is set to “Off” (lamp off) at the time of purchase.
Touch
button on the Control Panel to turn on the indicator lamp,
and touch
button to turn off “Save” indicator lamp.
Touch
button on the Control Panel to turn on the
indicator lamp.
All indicator lamps turn on, and then the current settings are displayed.
1
2
(At the time of purchase) (At the time of setting)
Touch it
Light ON
Ca
nc
el
Swing partition
EN
ER
GY
S
AV
IN
G
BB0055761S_R-XG480KH_A.indd 61
19.9.30 2:28:07 PM
