49
Push this button for
more than 5 seconds
How To Remove Parts / How to Maintain the Automatic Ice Maker
HOW TO MAINTAIN THE AUTOMATIC ICE MAKER
3
When using for the fi rst time / When not used for more than one week
Clean it once a year
If it is not used for a long time
Clean it once a week
Ice tray and water supply line can be washed.
Be sure to check the followings before starting the operation.
Go to the next step after checking them.
●
Remove the seal from the lid and wash it with a soft wash sponge.
●
How to open the lid
●
How to close the lid
1
1
1
Push the
button and hold it for more than 5 seconds
after closing all the doors and turning on the display.
When the three indicator lamps
ݨఀყϕ
(Quick Ice Making) ,
ყϕ
(Ice
Making) and
停止
(Stop) start to blink and alarm starts to sound, stop
holding the button.
ყϕጠ଼ᇓ
(Ice Maker Cleaning) starts.
Lay a soft clean towel on the
bottom of the ice case.
This is to suck water drained from Ice Maker Cleaning, preventing it
from spilling out of a cutout located behind in the Ice Maker case.
Before removing
the case, wipe off
the water in the
case.
Push the
button to stop supplying water to the ice tray
and turn on the
̥
(Stop) indicator lamp. (Stop ice making)
Empty the ice tray and wash it lightly in the stream.
Push the
button to light the
製冰
(Ice Making)
indicator lamp. (Automatic Ice Making starts)
Turn the case and remove it
from the lid.
Pull the tab of the water fi lter with
fi ngers and remove it from the case.
Wash it with a soft wash
sponge etc.
About three minutes later, when alarm and blinking
end, remove water in the ice case using the towel.
Open the Ice Compartment Door.
①
Push the level laterally.
②
draw the frame.
③
Raise the cover (
▲
part) in the direction of the arrow.
④
Remove the ice tray from the frame.
・
The indicator lamp will fl ash and the buzzer will sound for about 3 minutes.
・
ყϕጠ଼ᇓ
(Ice Maker Cleaning) can’t be interrupted.
・
If you open any of the refrigerator doors during Ice Maker Cleaning, the cleaning
may not work properly. Do not open or close the door until cleaning is completed.
・
Door alarm sounds even if alarm is disabled.
Pg.54
Water which doesn't contain chlorine may easily cause slime and/or fur
compared with tap water. Wash the Water Supply Container regularly to
prevent bacteria from breeding when such water is used.
There is no problem with using
water remaining in the water
supply container, if any.
※
If the indicator lamp
fl ashes, perform the
following operation after
the “
停止
(Stop)” lamp is
turned on in 1 minute.
2
2
2
3
3
●
Water supply container
・
Water is fi lled in it.
・
The container is set properly as specifi ed.
●
Ice case
・
If there remains ice, remove it.
About
5 seconds
1 beep
Water supply
cover
Seal
(Front)
Insert the lid from its rear side and
close it in the direction of the arrow.
(Back)
Lid
Case
Water fi lter
Water supply
container
To prevent malfunction, lay the
towel so that its thickness does
not reach this line.
Cutout
Container-full
line
Add water line
Tab
(Replace it normally every 3
〜
4 years.)
Pg.53
Do not use the
detergents etc.
Do not use a sponge /
cleanser, etc.
●
If you set ice making to Stop and do not intend to use the auto ice maker for some time, wash and dry the water supply container
and then mount it in place.
●
In particular, dry the water fi lter thoroughly.
●
Clean it once every three days for mineral water, wall water,
fi ltered water, cooled hot water (with no chlorine contained), etc.
Notice
Cover
4
Frame
Lever
Click
Click
①
Set the ice tray and
②
close the cover.
③
Keep the frame horizontal, and then push the
lever to the end until it gets hooked on the frame.
●
When the frame for the ice tray cannot be pushed into the back, the motor that drives the ice-tray may have operated. Remove the ice tray and then push the frame alone into
the back, and then push the
with all the doors opened to turn on
̥
(Stop) . After a while, the ice-tray driving motor gets ready, allowing you to mount the ice-tray.
Notice
4 long beeps
●
Do not place your hand in the
mechanical section of the automatic
ice maker. (Rotation of the ice tray
may cause injury.)
Warning
Washing the supply channel (Ice Maker Cleaning)
Ice tray
Water supply container
Cleaning the water fi lter
Light
ON
Push this button to turn on the
停止
(Stop) indicator lamp.
Light ON
Push this button to turn
on the indicator lamp
