38
Turn the left
Adjustable mount
to lower the left
side of the door.
Turn the right
Adjustable mount
to lower the right
side of the door.
3
3
■
The right side door is lower.
■
The left side door is lower.
1
1
Leg cover
Adjustable mounts
2
1
2
1
Installing your refrigerator
●
The floor should be sturdy and flat.
Lay a board with 1cm thickness on the floor if the refrigerator is installed on the carpet, tatami mat, flooring or PVC sheet flooring
which may be hollow or discolor.
●
Place the refrigerator away from direct sunlight and heat.
●
Do not place it in damp areas, and ensure good air ventilation.
This will reduce adverse effects to refrigerating power and keep electricity cost down.
This will also prevent the refrigerator from discoloring and rusting.
●
The place separated from other equipment.
To prevent disturbance (noise / scattered image) to TV and others attributable to the
refrigerator.
●
To cool efficiently, allow enough space around the refrigerator for radiating heat.
●
The actual size of the center part of the side of the refrigerator's main body is slightly
larger than the nominal size. Therefore, please allow enough space around when
installing the refrigerator.
●
The back of the refrigerator can be placed very close to the wall. If any vibration sound occurs
and/or any discolor/dirt is found on the wall, move the refrigerator away from the wall.
Fix the refrigerator
Adjusting the refrigerator adjustable mount to keep it level
●
Left side or right side of the door may be slightly lower when the surface of the installation place is not level or either of the left and right
leg sinks in the floor surface because of the soft floor material and the addition of food weight.
→
This does not affect the refrigerator function. Adjust the refrigerator adjustable mount to keep it level according to the procedure listed below if
you want to correct it.
Correcting any left/right lean and lifting slightly the front side of the refrigerator until the door can close easily and completely.
To remove leg cover, hold both ends of it and pull it
towards to you by applying some force.
●
The adjustable mounts, which are located in the front bottom corners of the refrigerator, can be adjusted by turning them
to level the refrigerator. (Make sure to use a supplied tool and pads (2 pcs.))
Turn the adjustable mounts to lower to the floor, and
then secure it at two (right and left) points.
Turn the adjustable mount on the opposite side of the area where
the door is lowered so that the Refrigerator Compartment door
will be horizontal.
The height of the door can be adjusted 1mm every one turn of the adjustable mount.
Insert the left and right pins of the
leg cover into the mounting holes to
attach the leg cover.
It may be approx. 5 days before the refrigerator
conforms to the floor allowing the door to be
leveled. Readjustment is required if the door is
not leveled.
2
1
Mounting hole
Fork
Leg cover
BEFORE USE
Preparation before use
1
2
3
Required space above the refrigerator:
5 cm or more
Required space for right and
left of the refrigerator: 1 cm or more
●
When you release your hand from a refrigerator door with the door open, the door may move, but this is normal.
Notice
BB0040171U_R-S42EMSH_C.indd 38
15.6.18 11:07:35 AM
