Hitachi R-MX800GVGV0, Instruction Manual

Page: 21 / 64

Ice Bank
Before performing maintenance, make sure that the refrigerator is unplugged.
1. Wipe the Ice Bank dry with a soft cloth.
1. Grasp the top of the Ice Bank with both hands.
Then, lift it up and pull it towards yourself.
2. After removing the ice, wipe the Ice Bank with a soft cloth,
being careful to remove any water in or on the Ice Bank.
If there are still ice cubes remaining in the Crusher Case in the reverse side of the Ice Bank, remove them using a spoon, etc..
Instructions for Regular Cleaning
Instructions for Removing and Cleaning the Ice Bank
Flapper
Blade
Crusher Case
21
If there is a gap, rotate the Auger 90 degrees and then install the Ice Bank.
3. When installing the Ice Bank, be sure that there
is no gap at the bottom of the Ice Bank.
GAP
90
Before performing maintenance, make sure that the refrigerator is unplugged.
Do not put your hands inside the Ice Bank.
Do not use the Ice Dispenser when the Ice Bank is removed from the refrigerator.
Do not disassemble, repair, or modify this equipment.
When repairs are necessary, contact retailers or service center.
Do not touch the blades of the Ice Bank when it is removed. There is a risk of injury.
Auger
Crusher Case
NOTICE
1. To stop the operation, touch
the "Ice Maker" button.
●
If there are still ice cubes remaining in the Crusher Case in the
reverse side of the Ice Bank, remove them using
with a spoon, etc..
●
When not using the Ice Dispenser for a long time, thoroughly clean and dry the Ice Bank and reinstall.
2. Remove ice in the Ice Bank, clean and dry the ice Bank and reinstall
it to its place in the refrigerator.
●
In this case, if ice is not removed from the Ice Bank, Ice cube may stick together cuasing the Ice Dispenser cannot operate.
Pipi!
Lamp lights off.
WARNING
●
●
●
●
●
Be careful, as the Ice Dispenser rotates and may cause injury.
CAUTION
How to use lce and Water Dispenser