5
/
9
11. The service life of carbon brush is around 1600 hours, please note and replace it in
advance.
12. Flat welding shoe and 90-degree welding shoe are suitable for different welding ways.
Please rotate then pull the welding shoe when you need to replace it, do not pull directly.
13. Please turn off the power switch on the green control panel if there is no welding rod
feed. Do not keep extruder on working status more than 5 minutes
Precautions for Use (The Content on the Label)
1. Extrusion gun pre-heating stage:
Pre-heating the extrusion gun on the shelf,
carefully check the power plug and prevent fall off.
2. Hot air gun pre-heating stage:
Press “POWER” button for one second to start the
hot air gun, press “+” and “-” button to adjust the setting temperature.
3. Melting pre-heating stage:
Press “ON/OFF” to start the green control box,
self-heating to the setting temperature.
Caution a:
If the melting temps do not reach to setting temp, motor trigger switch
self-locking and can’t press.
Caution b:
the default temp of motor self-locking is 260
℃
, pls contact manufacturer if
you want to change the default temp.
Caution c:
Green control box display the setting temp and real-time temp, you can press
“↑” and “↓” button to adjust.
Caution d:
Do not increase motor speed before not increase the heating temp,
otherwise will destroy the rotor.
4. Power Off:
Must extrude out all plastic materials (Judgment: when the voice getting
lighter).
Caution:
After extruding out all materials, adjust the hot air gun to cold wind for at least
5mins, then power off the extruder.
Ⅴ
.
Product Warranty
1. The welder has a warranty period of 1 year from the date of shipment.
2. After receiving the machine, the user should check if the machine is in good condition.
If there is no echo within two days, it shall be deemed to be complete and accepted by
user.
