24
Power Swivel
• This feature controls the motorized stand. It allows turning the plasma display left or right using the remote control.
Make sure that the main power switch of the monitor is turned off when removing or connecting the power cord, the connector cables, and
the speaker cables.
CAUTION
1. Press Swivel button.
The controlling icon appears on the screen.
• If the connecting cable is not connected, the indication "Not Available" appears.
• The swivel display disappears in about 6 seconds if left without any operation.
Swivel
2. Adjust for preferred angle.
Adjust by using
key whilst the swivel display is on the screen.
Swivelling angle of the monitor is available within
30 degrees from the front face.
ATTENTION
• Do not push the panel manually whilst using the swivel function. It could cause damage to the stand or panel.
• Do not get on and/or hang down the monitor. Do not swing the monitor back and forth and around either. It could cause the failure of the
stand.
• Do not put hands or faces close to the monitor whilst operating the swivel function. It could cause a physical injury. Use special caution in
households where children are present.
• Do not put any object, like a vase, near the monitor in swiveling area. It would cause a breakage of the object and /or a failure of the stand.
• Place the monitor on the stable location, or the swivel function would not operate correctly. It would cause the malfunction.
• In the case of using the monitor wall mounted, be sure to detach the connecting cable between the monitor and the stand.
Caution when connecting the monitor with the stand
• When detaching the stand from the
monitor, make sure to detach the
connector cable from the stand
connection terminal on the rear of the
monitor.
• Make sure that the direction of the connector for stand connecting cable is correct.
• When attaching the stand to the
monitor once again, insert the
connector cable into the stand
connection terminal on the rear of the
monitor.
Pinch right and left
locks of the connector
and pull out downward.
Insert until it clicks.
BASIC OPERATION (continued)
