Drainage elbow and drain hose installation
Install Drainage Elbow and Drain Hose
•
The condensate water may drain from the outdoor unit when
the unit operates in heating mode. In order to avoid disturbing
neighbors and protect the environment, it is necessary to
install a drainage elbow and a drain hose to drain out the
condensate water.
• Please do the drainage work before the indoor unit and
outdoor unit are connected. Otherwise, it will be difficult to
install drainage elbow after the machine becomes immovable.
• Connect the drain hose (field-supplied, inside
diameter: 15mm) as shown in the figure for drainage.
Drain hose
Drainage elbow
NOTE:
Do not use the drainage elbow in a cold region. Drain may freeze
to stop the fan runs.
Outdoor unit installation
1
Use the washer provided in the accessory to fasten the machine at the foundation bolts.
2
When fastening the outdoor unit with the foundation bolts, the fasten holes position is shown at the Fig. 1.
3
Fasten the outdoor unit as the Fig. 2.
4
Make sure to fasten the outdoor unit tight and horizontal to prevent noise when the machine is oblique or inclined by strong
breeze or earthquake.
5
Do not drain off water to public places to avoid to skidding.
6
A strong base (made of concrete, etc.) should be made. The appliance should be placed not less than 10 cm high to avoid being
wet or corroded. Otherwise, it may cause damage to the appliance or reduce its life time. (Fig. 3)
7
Fix the unit with wire ropes to prevent overturning in case that a strong seasonal wind blows against the unit (Fig. 4).
(Unit: mm)
Model
A
B
C
D
E
F
d
3.0/3.5HP
860
310
542
341
368
168
11x17
4.0/5.0/6.0/6.5HP
950
340
580
380
414
185
15
Fig. 1
Setscrew
(at least 4)
Min. 10cm
About
10cm
About
40cm
Concrete base, etc.
Fig. 3
Cut it off, if the bolts are
too long, or it will be
troublesome of the moving
in the future.
Anchor bolt
Beton
Max.
21mm
Fig. 2
Wire ropes
Fig. 4
INSTALLATION INSTRUCTIONS
HO2019292HA
11
EN