English
4
SPECIFICATIONS
STANDARD ACCESSORIES
(1) Depressed center wheel ............................................ 1
external dia.
100 mm
thickness
3.5 mm
hole dia.
16 mm
(2) Wrench ........................................................................ 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES . . sold separately
CAUTION:
Always operate the grinder with the wheel guard
attached.
1. 100mm Sanding Disc Set
In case when only a relatively small metal surface
area is to be polished and it is desired to give it a
particularly fine finish, this is used for preliminary
polishing of the metal surface before applying point,
for removing rust, and for removing point when a
new test is to be applied.
There are eleven different kinds of sanding discs,
having grains of #16, #20, #24, #30, #36, #40, #50,
#60, #80, #100, #120. When placing your order, please
specify the grain of the disc desired.
2. Diamond Wheel Set
This is used for cutting and scribing of concrete,
stone, tile etc.
Optional accessories are subject to change without notice.
*
Be sure to check the nameplate on product as it is subject to change by areas.
Voltage (by areas)*
(220V, 230V, 240V)
Power Input*
760 W
No-Load Speed
12,000/min
Wheel size
external dia.
100 mm
thickness
Max. 6 mm
hole dia.
16 mm
Weight (without cord)
1.9 kg
APPLICATIONS
䡬
Removal of casting fin and finishing of various types
of steel, bronze and aluminum materials and castings.
䡬
Grinding of welded sections or sections cut by means
of a cutting torch.
䡬
Grinding of brick, marble, etc.
䡬
Cutting and scribing of concrete, stone, tile, (use the
diamond wheel)
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Grounding
This tool should be grounded while in use to protect
the operator from electric shock. The tool is equipped
with a three conductor cord and grounding type plug
to fit the proper grounding type receptacle. The green
(or green and yellow) conductor in the cords is the
grounding wire. Never connect the green (or green
and yellow) wire to a live terminal.
3. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
4. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
5. Confirming condition of the environment
Confirm that the work site is placed under appropriate
conditions conforming to prescribed precautions.
When grinding a thin steel plate, depending upon the
state of the workbench, a loud noise will be created
due to resounding noise from the steel plate being
ground. To eliminate nuwanted noise in this instance,
place a rubber mat beneath the material to be ground.
6. Mounting the wheel guard
Be sure to mount the wheel guard at an angle that
will protect the operator’s body from injury by a
broken wheel piece.
Washer Nut
Sanding Disc
Rubber Pad
Washer
Guide Base Ass’y
Diamond Wheel
Segment
Type
Summary of Contents for PDA-100H
Page 12: ...11 ...
