5
English
NOTE:
Be careful not to deform the collated wires and not to
disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
4
Pulling the nails to the right, swing the nail guide
closed. (
Fig. 6
)
(7) Lock the knob completely.
HOW TO USE THE NAILER
CAUTIONS:
䡬
Never use the head or body of this device as a
hammer.
䡬
Take precautions to ensure the safety of persons in
the vicinity during operation.
1.
This Nailer is equipped with the push lever and does
not operate unless the push lever is depressed
(upward position).
There are two methods of operation to drive nails
with this Nailer.
They are:
1. Intermittent operation (Trigger fire)
2. Continuous operation (Push lever fire)
(1) Intermittent operation (Trigger fire)
1
Position the nail outlet on the workpiece with
finger off the trigger.
2
Depress the push lever firmly until it is completely
depressed.
3
Pull the trigger to drive a nail.
4
Remove finger from the trigger.
To drive another nail, move the Nailer along the
workpiece and repeat this procedure. (
Fig. 7
)
Fig. 7
(2) Continuous operation (Push lever fire)
1
Pull the trigger with the Nailer off the workpiece.
2
Depress the push lever against the workpiece to
drive a nail.
3
Move the Nailer along the workpiece with a
bouncing motion.
Each depression of the push lever will drive a
nail.
As soon as the desired number of nails have been
driven, remove finger from the trigger. (
Fig. 8
)
Fig. 8
CAUTION:
Exercise care when nailing corners of lumber. When
continuous nailing corners of lumber, a nail may go
astray or break through the corner.
NOTES:
䡬
Precautions on no-load operation
Sometimes nailing will continue after driving in all
nails previously contained in the magazine.
This is termed “no-load operation”. Such operation
may deteriorate the bumper, magazine, and nail
feeder.
To avoid no-load operation, occasionally confirm the
amount of remaining nails. On the other hand, all
nails should be removed after using this nailer.
䡬
After completing operation, put into the body about
2cc oil through the hose joint to protect the tool from
rust.
䡬
Under low temperature conditions, the machine
sometimes does not operate correctly. Always operate
the machine at the appropriate ambient temperature.
2. Adjusting the nail-driving depth
CAUTIONS:
When making adjustments, be sure remove your
finger from the trigger. When making adjustments,
be sure that the nail outlet is not facing downward
and that body parts or other persons are not in the
path of the nail outlet.
䡬
Adjusting the adjuster (
Fig. 9
)
Carry out test driving. If the nails are too deep, turn
the adjuster to the shallow side (
mark).
If the nail depth is too shallow, turn the adjuster to
the deep side (
mark). (See
Fig. 9, 10
)
Depth is changed 1 mm with each rotation of the
adjuster.
Fig. 9
Adjuster
Deep
Shallow
Push Lever
Trigger
Previously pull
the trigger
2
3
1
3
01Eng_NV65AH_WE
9/11/11, 2:47 PM
5
