9
English
5
Loosen wing bolt, and raise until indicator aligns
with the graduation representing the desired
cutting depth. Tighten wing bolt.
6
Loosen the lock lever and press the tool body
down until the stopper block to obtain the
desired cutting depth.
(2) As shown in Fig. 6 (a), loosening the two nuts
on the threaded column and moving them down
will allow you to move down to the end position
of the bit when the lock lever was loosened. This
is helpful when moving the router to align the bit
with the cutting position. As shown in Fig. 6 (b),
tighten the upper and lower nuts to secure the
cutting depth.
Fig. 6
(3) When you are not using the scale to set the
cutting depth, push up the stopper pole so that it
is not in the way.
2. Stopper block (Fig. 7)
The 2 cut-depth setting screws attached to the
stopper block can be adjusted to simultaneously
set 3 di
ff
erent cutting depth. Use a wrench to
tighten the nuts so that the cut-depth setting
screws do not come loose at this time.
Fig. 7
3. Guiding the router
WARNING
Be sure to switch power OFF and disconnect
the plug from the receptacle to avoid serious
trouble.
●
Ensure that the lock pin is not inserted into
the armature shaft after tightening the collet
chuck. Failure to do so will result in damage
to the collet chuck, lock pin and armature
shaft.
2. Removing bits
When removing the bits, do so by following the
steps for installing bits in reverse order.
CAUTION
Ensure that the lock pin is not inserted into
the armature shaft after tightening a bit.
Failure to do so will result in damage to the
collet chuck, lock pin and armature shaft.
HOW TO USE THE ROUTER
1. Adjusting depth of cut
(1) Use stopper pole to adjust depth of cut.
1
Place the tool on a
fl
at wood surface.
2
Turn the stopper block so that section to which
the cutting depth setting screw on a stopper
block is not attached comes to the bottom of
the stopper pole. Loosen wing bolt allowing the
stopper pole to contact with stopper block.
Fig. 4
3
Loosen the lock lever and press the tool body
until the bit just touches the
fl
at surface. Tighten
the lock lever at this point. (Fig. 5)
Fig. 5
4
Tighten wing bolt. Align the depth indicator with
the “0” graduation of scale.
Stopper pole
Scale
Stopper
block
Depth
indicator
Wing bolt
Loosen the
lock lever
Nuts
Threaded
column
(b)
(a)
Cut depth
setting screw
000Book̲M12VE̲US.indb 9
000Book̲M12VE̲US.indb 9
2009/08/06 18:23:05
2009/08/06 18:23:05
Summary of Contents for M 12VE
Page 41: ...41 000Book M12VE US indb 41 000Book M12VE US indb 41 2009 08 06 18 23 08 2009 08 06 18 23 08 ...
Page 42: ...42 000Book M12VE US indb 42 000Book M12VE US indb 42 2009 08 06 18 23 08 2009 08 06 18 23 08 ...
Page 43: ...43 000Book M12VE US indb 43 000Book M12VE US indb 43 2009 08 06 18 23 08 2009 08 06 18 23 08 ...