Hitachi L42VK06U, Instructions For Use Manual

Page: 12 / 43

English - 7 -
Headphone Volume
Excessive sound pressure from earphones
and headphones can cause hearing loss.
Installation
To prevent injury, this device must be securely
attached to the wall in accordance with the installation
instructions when mounted to the wall (if the option
is available).
LCD Screen
The LCD panel is a very high technology product with
about a million thin fi lm transistors, giving you fi ne
picture details. Occasionally, a few non-active pixels
may appear on the screen as a fi xed blue, green or
red point. Please note that this does not affect the
performance of your product.
Warning
Do not leave your TV in standby or operating mode
when you leave your house.
•The Standby / On button doesn´t separate this
device completely from mains. Moreover the device
consumes power in the standby operation. In order
to separate the device completely from mains, the
mains plug has to be pulled from the mains socket.
Because of that the device should be set up in a
way, that an unobstructed access to mains socket
is guaranteed, so that in case of emergency the
mains plug can be pulled immediately. To exclude
the danger of fi re, the power cord should principally
be separated from the mains socket prior to a longer
period of non-usage, i.e. during vacations.
Electrical device not in the hands of children
Never let children use electrical device unsupervised.
Children can´t always recognize properly the
possible dangers. Batteries / accumulators can be
life threatening when swallowed. Store batteries
unreachable for small children. In case of swallowing
a battery medical aid has to be sought immediately.
Also keep the packaging foils away from children.
There is danger of suffocation.
Inserting Batteries in the
Remote Control
• Remove the battery cover located on the back of
the remote control by gently pulling backwards from
the indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the right directions and
replace the battery cover.
+
+
-
-
Note : Remove the battery from remote control when it is not
to be used for a long period. Otherwise it can be damaged
due to any leakage of batteries.
Remote range is approximately 7m/23ft.
Switching the TV On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC 50 Hz.
Please Note : On/off switch is located on the left-hand
side of the TV (from front view).
• Switch the “ ” button to position “ | ” so the TV
will switch to standby mode. Then the standby LED
lights up.
• To switch on the TV from standby mode either:
• Touch the “ ” button, P+ / P- or a numeric button
on the remote control.
• Touch the “ ” or +/- button on the TV.
The TV will then switch on.
Note : If you switch on your TV via PROGRAMME UP/DOWN
buttons on the remote control or on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on.
To Switch the TV Off
• Switch the “ ” button to position 2 as illustrated,
so the TV will switch OFF .
• To power down the TV completely, unplug the
power cord from the mains socket.
Note : When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Searc h or
Over Air D ownload is active.
Note : This is normal operation and is not considered as a
fault.
Note : The TV switch on time is about 23 seconds please do
not touch the ON button again during this time as this will
return the TV to Stand by mode.