Hitachi Innovate ED-X26, User Manual

Page: 43 / 99

34
SETUP menu
SETUP menu
From the SETUP menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons, and
press the ► cursor button or
ENTER button to
execute the item. Then perform it according to the
following table.
Item Description
KEYSTONE
Using the ◄/► buttons corrects the vertical keystone distortion.
Shrink the bottom of the image Shrink the top of the image
• The adjustable range of this function will vary among inputs. For
some input, this function may not work well.
• When the zoom adjustment is set to the TELE (telephoto focus),
this function may be excessive. This function should be used when
the zoom adjustment is set to the full WIDE (wide-angle focus)
whenever possible.
AUTO ECO
MODE
Using the ▲/▼ buttons turns on/off the AUTO ECO MODE.
ON OFF
• When ON is selected, the projector will always be set to Eco mode
at start-up regardless of the ECO MODE (
below
) setting. An OSD
message “AUTO ECO MODE” will be displayed for tens of seconds
when the projector starts with this function activated.
ECO MODE
Using the ▲/▼ buttons turns off/on the eco mode.
BRIGHT NORMAL
• When the NORMAL is selected, acoustic noise and screen
brightness are reduced.
MIRROR
Using the ▲/▼ buttons switches the mode for mirror status.
NORMAL H:INVERT V:INVERT H&V:INVERT
STANDBY MODE
Using ▲/▼ buttons switches the standby mode setting between
NORMAL and SAVING.
NORMAL SAVING
• When SAVING is selected and the projector is in the standby
state, the power consumption is lowered with some functional
restrictions as below.
- The STANDBY of the MONITOR OUT (
35
) is invalid, and no
signal is output from the MONITOR OUT port.
- The AUDIO OUT STANDBY of the AUDIO SOURCE (
36
) is
invalid, and no signal is output from the AUDIO OUT ports (
5
).
(continued on next page)