Hitachi HTD-K185UK, Instruction Manual

Page: 53 / 74

Ä 52
PREPARATION 1
SWITCHING ON
Turn on your TV set and select the SCART input (with the AV key, or similar, on thetelevision remote control). Turn
on the mains supply to the DVB - T receiver (the indicator on the front of the receiver will glow red) and press the
[STANDBY] key on the DVB - T remote control handset. After exiting standby the system turns on DVB mode.
If you do not see the receiver's menu on the television screen, refer to the Troubleshooting .
TUNING IN
Because this is the first time that the receiver has been used, there are no channels stored in the receiver's memory
and the Autosearch selection menu is displayed on the screen.
Using the [LEFT] or [RIGHT] keys on the remote control, make sure that the YES button is highlighted in yellow, and
press the [SELECT] key to start the automatic search.
The DVB - T receiver will automatically tune to the UHF transmission channels 21 to 68 looking for digital terrestrial
TV broadcasts and displaying the names of channels found. This process will take about five minutes.
'R\RXZDQWWRVWDUWDXWRPDWLFVHDUFK"
<HV 1R
When the search is finished, the first channel of the channel list and the information banner is displayed you can
now watch digital terrestrial television, selecting the channel you require as described in the next section.
HINT
Depending on the reception conditions in your particular area, you may find that the list of channels
found includes one or more repeated names. This is because the receiver may detect and store some
channels, including those it cannot receive clearly, from adjacent areas alongside the strong channels
from a transmitter nearby. This is not a problem and the weaker channels can be deleted from the
receiver later, as described in - ADVANCED OPERATION - Section Editing the channel list.
If no digital terrestrial television broadcasts are found the receiver will display a message:
You should then refer to the Troubleshooter Guide in Appendix E to establish the cause of the problem.
When you have finished watching digital terrestrial TV, you may wish to switch the receiver to standby to save power
- although the DVB - T receiver can remain powered up continuously, even when the television is turned off, without
harm to the television or itself. The receiver is returned to standby by pressing the [STANDBY] key on the remote
control handset.
DVB-T